Find Existing Ford Excursion Car Recalls

CERTAIN PICKUP TRUCKS, SPORT UTILITY VEHICLES AND VANS EQUIPPED WITH 6.0L DIESEL ENGINES MAY EXPERIENCE STALLING WITHOUT WARNING WHILE DRIVING AND MAY OR MAY NOT RESTART.

DEALERS WILL UPGRADE THE FUEL INJECTION CONTROL MODULE (FICM) WIRE HARNESS OR REPLACED, AND/OR HAVE A NEW INJECTION CONTROL PRESSURE (ICP)) SENSOR CONNECTOR INSTALLED. THE RECALL IS EXPECTED TO BEGIN ON JULY 5, 2005. OWNERS SHOULD CONTACT FORD AT 1-800-392-3673.

FIND YOUR LOCAL Ford Service Centre

On certain passenger and sport utility vehicles, pickup trucks, and minivans equipped with seat belts supplied by TRW, it is possible that the driver's and/or outboard front passenger's seat belt buckle may not fully latch In the event of a crash, the restraint system may not provide adequate occupant protection, increasing the risk of personal injury to the seat occupant. The vehicles equipped with these belts include Ford Crown Victorias built at St. Thomas Assembly Plant from 4/17/00 - 5/29/01; Mercury Grand Marquis built at St. Thomas Assembly Plant from 4/17/00 - 5/29/01; Lincoln Town Cars built at Wixom Assembly Plant from 3/27/00 - 5/30/01; Lincoln Navigators built at Michigan Truck Plant from 4/11/00 - 5/31/01; Ford Windstars built at Oakville Assembly Plant from 3/23/00 - 5/30/01; Ford Rangers built at Twin Cities Plant from 3/28/00 - 5/30/01 and also at the Edison Plant from 3/13/00 - 5/25/01; Ford F-150 trucks built at the Norfolk Plant from 4/18/00 - 5/25/00, at the Onta...

Dealers will inspect the front outboard seat belt buckles. If a buckle fails the inspection process, it will be replaced. The manufacturer has reported that owner notification began on July 25, 2001. Owners who do not receive the free remedy within a reasonable time should contact Ford at 1-866-436-7332.

FIND YOUR LOCAL Ford Service Centre

On certain passenger cars, sport utility vehicles, and light and medium duty pickup trucks, a switch located in the plastic cover of the wiper motor gear case could malfunction and overheat, potentially resulting in loss of intermittent wiper function, loss of wiper park function, complete loss of wiper function, smoke, or ignition of the plastic cover material. Switch malfunction is most likely to occur when the intermittent setting of the wipers is being used, or when snow or ice obstructs the blades from returning to the "parked" position at the bottom of the windshield. These vehicles were built at the following assembly plants: Atlanta plant from 2/11/00 through 7/31/00; Chicago plant from 2/14/00 through 8/4/00; Kansas City plant from 2/26/00 to 9/4/00; Kentucky truck plant from 2/18/00 to 8/31/00; Michigan truck plant from 2/23/00 through 8/3/00; Norfolk plant from 2/21/00 through 7/27/00; Wayne Stamping and Assembly plant from 2/25/00 through 8/15/00; and Wixom plant from 2/...

Dealers will inspect the date code on the wiper motor. Motors built within the suspect time frame will have the wiper motor gear case cover replaced. The manufacturer reported that owner notification would begin during September 2001. Owners who do not receive the free remedy within a reasonable time should contact Ford at 1-866-436-7332.

FIND YOUR LOCAL Ford Service Centre

On certain passenger and sport utility vehicles, due to the use of incorrect material by a supplier, the headlamp switch knob can fracture and separate from the headlamp switch. This would cause difficulty for the driver to activate the headlamps, which could affect driver visibility, increasing the risk of a crash.

Dealers will replace the headlamp switch knob. The manufacturer has reported that owner notification began on March 26, 2001. Owners who do not receive the free remedy within a reasonable time should contact Ford at 1-800-392-3673.

FIND YOUR LOCAL Ford Service Centre